Mini Series – Portable Winches

Posted by on Jul 29, 2014 in Winches | Comments Off on Mini Series – Portable Winches

Mini Series – Portable Winches

Mini borehole logging winch geophysics

Description

The “Mini” winch is a logging hoist, capable of positioning a geophysical probe or other tools in a borehole. The system is equipped with slip ring and connections through which surface instrumentation can communicate with the probe. A precision measuring wheel and rotary encoder are also included to allow the amount of cable played out to be tracked. The cable is wrapped on the drum in even layers through a manually operated, tiller arm.

The motor is controlled by an 110V or 220V four-quadrant motor speed controller that allows the speed to remain constant with a varying load and prevents over-driving with heavy loads. The winch is used in conjunction with the current Matrix or Scout consoles (or the older Bbox or MGX II loggers) with the proper mounting rails, and a portable PC to achieve a complete logging system.

 

Mini borehole logging winch geophysicsMini borehole logging winch geophysics

There are four models in the Mini winch line:

  • MW-1-0-7-3-200: Spooled with 200 meters of 3.17 mm (0.125 in.) diameter single conductor wireline, 120vac.
  • MW-2-0-7-3-200: Spooled with 200 meters of 3.17 mm (0.125 in.) diameter single conductor wireline, 220vac.
  • MW-1-0-7-5-305: Spooled with 305 meters of 2.54 mm (0.100 in.) diameter single conductor wireline, 120VAC.
  • MW-2-0-7-5-305: Spooled with 305 meters of 2.54 mm (0.100 in.) diameter single conductor wireline, 220VAC.

Mini winches are set at the factory to operate at either 110VAC or 220VAC and cannot run at another voltage. If the winch is configured for 220 AC, there will be a red label below the POWER IN connector indicating 220 VAC. The Matrix can automatically switch between 110 and 240 VAC.

It is important to prevent kinking the logging cable to not damage the insulated center conductor. The wireline cablehead should be inspected periodically for electrical and mechanical integrity. To prevent loss of tools, we recommend re-heading every three months or more often as conditions indicate.

NOTE: When using a DC inverter to power the winch, a true sine-wave inverter is required for smooth winch operation. Minimum power requirement for such an inverter is 600 watts, which should also allow operation of the logger.

Miniwinch with Matrix logging console

Documentation

Winch Series Brochure: English

Folleto de los winches: Espanol

Miniwinch Operations Manual

Print Friendly, PDF & Email